Your shopping cart is empty
Browse through our categories and we are sure
you will find what you are looking for!
you will find what you are looking for!
Declaration
Technical characteristics | LLS XY 3300 |
|---|---|
Table type | CNCSS 2550 TPB |
Maximum glass sheet dimensions (mm) | 3300x2550 |
Minimum glass sheet dimensions (mm) | 350x350 |
Maximum cutting speed (m/min) | 150 |
Maximum grinding speed (m/min) | 75 |
Grinding tools | Standard grinding wheel Ø200/Ø76 x 20mm |
Cutting irregular shapes (circle, ellipse) | No |
Grinding irregular shapes (circle, ellipse) | No |
Belt transport system | Yes |
Pneumatic positioning system | Yes |
Automatic laser positioning to the zero point | Yes |
"Air cushion" | Yes |
Number of racks | 4 |
Loader mode | Automatic and manual |
Total length (mm) | 18700 |
Total width (mm) | 9400 |
Power (kW) | 20 |
More Information
Glass cutting and breaking line LLS XY 3300 is used for cutting and breaking flat glass along X and Y axis and it ensures high productivity. The line is composed of Loader HSSK 4, Automatic glass cutting table CNCSS 2550 TPB, transport table, Y breaker, XY turning table, X breaker, second transport table and edge separating table.
The loader brings the glass down into a horizontal position from one of the racks. Glass is then transported to the automatic glass cutting table. Due to the line construction, the optimization software requires that the Y cut must always be along entire glass sheet width.
After cutting the belt system transports the cut glass sheet to the first transport table, which brings the cut line to the Y breaker, where the glass is broken. The broken piece of glass is turned by 90° and the second cut, if there is one, is brought to the X breaker. The operator calls for the final glass sheets using the foot pedal. The glass sheets are then transferred via the second transport table to the edge separating table. The cycle is repeated until the last glass piece.
Meanwhile, immediately after being available, the loader prepares the next glass sheet and waits for the cutting table to be ready for use. Choosing the next glass sheet can be automatic, as a result of the optimization software, or manual. The loader, table and the rest of the line are synchronized by the software and the system of sensors, so there is no time waste.